濟南裝載機是永保機械主營產品之一，我們公司擁有先進的技術力量、卓越的制造工藝、齊全的檢驗手段，是值得大家信賴的裝載機制造商。那么裝載機在我們的日常生活中應該如何維護呢？
1、一般氣溫在5℃以下,發動機起動前應加熱水或蒸汽進行預熱,待預熱到30~40℃以上再進行起動。
Usually the temperature below 5 ℃, the water should be heated before starting the engine or steam preheating, to be preheated to above 30 ~ 40 ℃ then start.  
2、當氣溫低于0℃時，應定時檢查防凍液濃度，同時禁止使用未經處理的水作為發動機的冷卻液；每天工作完后應將水箱下水室、發動機、機油冷卻器及變矩器油冷卻器里的冷卻水放出，以免凍裂；貯氣筒內有水汽,經常排放，防止凍結，致使剎車失靈。如果已加防凍液,可不放出。
When the temperature is below 0 ℃, should regularly check the antifreeze concentration, while prohibiting the use of untreated water as the engine coolant; work after a day should water tank room, engine oil cooler and torqueconverter oil cooling the cooling water is released in order to avoid cracking; water vapor within the air reservoir, often emissions, to prevent freezing, resulting in brake failure. If you have added antifreeze, do not release.   
3、冬季車輛使用相對困難,建議每次啟動不應超過8秒,如不能啟動,應松開啟動開關,待停車1分鐘后再作第二次啟動。
Winter vehicles is relatively difficult, it is recommended not more than 8 seconds each time you start, if not start, you should release the start switch, wait one minute and then stop for a second start.   
4、要在柴油機的水溫高于55℃、機油溫度高于45℃時才允許進行全負荷運轉;作業時發動機的水溫和油溫不應超過95℃,變矩器的油溫不應超過110℃。
To the water temperature is higher than diesel 55 ℃, when the oil temperature is higher than 45 ℃ allows full load operation; when operating the engine temperature and oil temperature should not exceed 95 ℃, the torque converter oil temperature should not exceed 110 ℃.   

濟南裝載機：http://m.juzhen5.cn/